Mini Off Road Forklift,Front End Forklift,Small Diesel Forklift

Forklift Hydraulic System Maintenance and Repair Sep 06 , 2024

The maintenance of big forklift truck hydraulic system is different from that of other mechanical systems. The maintenance of hydraulic system is relatively simple, but it has a great impact on the performance, efficiency and life of the hydraulic system. The maintenance of forklift hydraulic system can be carried out according to the following steps. 1. First, clean the dust on the surface of the...

Safety Technical Operating Procedures for Loaders Aug 28 , 2024

Safety and technical operating procedures for loaders 1. When the front wheel loader is driving, the bucket should be retracted and the bucket should be about 400-500mm off the ground. Pay attention to whether there are roadblocks or high-voltage wires during driving. No other people are allowed to ride except the specified drivers. 2. When the loader is driving, avoid sudden changes in direc...

How to Start A Forklift Safely Aug 20 , 2024

Before starting all terrain forklift, first check whether there are people, livestock and other obstacles beside and under the vehicle, and close the door. When starting, first step on the clutch pedal and shift gears; then release the parking brake, and check whether there are vehicles coming from behind through the rear view mirror; then release the clutch, appropriately step on the acceler...

Fault Inspection and Troubleshooting of Forklift Drive Motor Not Running Aug 07 , 2024

Fault inspection and troubleshooting of construction forklift drive motor not running 1. Switch not closed. (Battery connector, key switch, seat switch, direction switch or parking brake switch): Turn off the switch. If the drive motor still does not run, use a multimeter to detect the voltage and electrical pulses through each switch on the control board. But the foot switch should be on. 2. Inse...

How to Adjust a Forklift Forks Jul 12 , 2024

I. Adjust the load roller (bearing) of the forklift frame. Note: Standard, full free lift and full free three-stage lift fork load bearings are adjusted in the same way. The fully automatic three-stage lift fork is shown below. For fork adjustment, a mast gauge and an adapter that matches the mast gauge are required. The forklift fork must be removed from the forklift. Ⅱ. Select the bearing from t...

Analysis of Five Common Loader Brake System Failures Jul 02 , 2024

Mini articulating loaders play a vital role in today's engineering construction. A good understanding of the characteristics of the loader brake system and simple troubleshooting methods can ensure the normal use of the loader. The following takes the caliper disc brake system widely used in loaders as an example to explain the causes and treatment methods of loader brake system failures. 1. ...

Disassembly and Assembly Method of Forklift Crankshaft Flywheel Assembly Jun 27 , 2024

I. Disassembly and assembly sequence of forklift spare parts crankshaft and flywheel The disassembly sequence of crankshaft and cylinder block is as follows: 1. Remove the oil pan, then remove the oil pump, the front and rear oil seal flange bolts of the crankshaft, and then remove the oil seal flange and the intermediate shaft cover seat. Note that when disassembling the intermediate shaft of a g...

Is the backhoe loader practical? What are the advantages and disadvantages of the backhoe loader Jun 13 , 2024

Is the backhoe loader practical? What are the advantages and disadvantages of the backhoe loader? 1. Is the backhoe loader practical? The backhoe loader is a uniquely structured excavator with two buckets and two shovel arms. One bucket and shovel arm is used for excavation, and the other is used for rotation and unloading. So is the backhoe loader practical? 1. Land consolidation In rural areas, ...

News